Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Cable---_.._i
Cable AdJust- /
meo,
To,ii
Z" Hook
TO REMOVE
TOP COVER
• Follow these steps from operator's
position.
o Remove the T-knob and fasteners on the
discharge chute,
• Remove the gas cap.
• Remove the two bolts and nuts from the
front tip of the top cover. Use a flat head
screwdriver
and a 3/8" wrench.
• Remove the bolt from the front right side,
Use a 5/I6"
and 3/8" wrench,
• Remove the four screws on the left side
of the top cover. Use a large flat head
screwdriver°
• Remove the bolt from the front left Side.
Use a 5/16" and 3/8" wrench,
• Remove the four screws on the right side
of the top cover, Use a large flat head
screwdriver.
. Remove the three screws from the top
portion of the control panel Use a large
flat head screwdriver°
. Carefully pull up on the rear of top cover
making sure to clear gas tank,
• Carefully
lift top cover over the three bolts
holding the lower chute to the chute ring_
NOTE:
This area was designed to have
a tight fit, it will be necessary to rock top
cover carefully over these bolts.
• Remove lop cover.
. Reinstall in reverse order.
TO REMOVE
BELT COVER
• Follow these steps from operator's
position.
• Using a large flathead screwdriver,
remove the heat shield from the rear of
the belt cover.
• Remove the four bolts and nuts holding
the belt cover to the auger housing,
Use
a 5/16" and 3/8" wrench.
• Remove the two screws holding the belt
cover to the top cover. Use a large flat
head screwdriver,
NOTE: If the top cover
is already removed, omit this step.
• Remove the one screw holding the belt
cover to the bottom cover. Use a large flat
head screwdriver,
• Grasp the bottom portion of the belt cover
and pull down and out to remove,
, Using a large flathead screwdriver,
remove the heat shield from the rear of
the belt cover.
° Reinstall in reverse order.
Screws to be
Bolts to be
removed from Top
T_
Chute
Cover
Shield
Fasteners
Lower ;hute
Bolts to
to be
removed from
removed
Belt Cover
from Belt
Cover
TO ADJUST BRAKE PAD
The brake pad is adjusted at the factory and no
periodic adjustment
is necessary°
IMPORTANT:
Adjustment
should only be
made to the brake if the brake pad has
become loose or has been removed.
To
adjust proceed as follows:
NOTE:
See figure on next page for proper
location of brake pad,
• Turn engine off,
. Remove belt cover,, See To Remove Belt
Cover paragraph on this page,
• Remove the top cover
See To Remove
Top Cover instructions
on this page.
12
Tabla de contenido
