Connecting And Stowing The Cables; Installing The Device; Placing The Portable Kit In The Bag; Battery Information - Garmin Portable echo Manual De Instrucciones

5
Insert the 10-32×1.75 screw
transducer, spacer, and washers.
6 Fasten the screw with the 10-32 wing nut
7 Attach the suction cup to the side of your boat.
8
Align the transducer parallel with the water line.

Connecting and Stowing the Cables

Ensure that you connect the correct connector to the correct
battery terminal. Damage to the battery, device, or bodily harm
may occur if the device is improperly connected to the battery.
1
Using the cables you inserted through the pass-through
holes on the portable mount, compare the divot on the cable
connector to the keying on the echo device ports to identify
the correct port.
2 Push the cable connector into the correct port until the
connector is fully seated.
3
Repeat steps 1 and 2 until all of the cables are connected to
the device.
4
Slide the positive (red) connector onto the positive (red)
terminal on the battery.
5
Slide the negative (black) connector onto the negative
(black) terminal on the battery.
6
If necessary, wrap excess power cable around the open
section on the underside of the portable mount.
7
If necessary, wrap excess transducer cable around the
hooks on the side of the handle on the portable mount.

Installing the Device

1
Connect the power and transducer cables to the device.
2
With the locking arm
echo device into the swivel mount
3
Tilt the mount for the preferred viewing angle and press
down on the locking arm.

Placing the Portable Kit in the Bag

After you have assembled the portable kit mount, you can place
it in the bag, which makes it easier to carry and protects it from
the elements. The bag contains hooks that allow you to tether
the bag to a seat on your boat.
1
Place the battery in the open space behind the swivel mount.
2
Slide two of the included hook and loop straps through the
narrow slots near the battery.
3
Pull the straps under and around the bottom of the portable
mount, and wrap them tightly around the battery.
4
Place the transducer into the open space next to the swivel
mount.
through the transducer arm,
.
CAUTION
in the upward position, place the
.
5
Place the portable kit in the bag.
6
Wrap the flap of nylon found inside the bag around the
handle of the portable base and secure it to the opening flap.
7 Pull the opening flap over the handle.
8
Zip up the opening flap to close the bag.

Battery Information

Battery Warnings
Your GPS device uses a user-replaceable sealed lead acid
battery. If these guidelines are not followed, the battery may
experience a shortened life span or may present a risk of
damage to the device, fire, chemical burn, electrolyte leak,
and/or bodily injury.
• When storing the battery for an extended time, store within
the following temperature range: from 5° F to 104°F (from
-15° C to 40° C).
• Do not operate the battery outside of the following
temperature range: from 5° F to 122° F (from -15° C to 50°
C).
• Do not place the battery near objects that may cause sparks,
flames, or heat.
• Do not incinerate the battery.
• Keep the battery tightly closed.
• Do not use a sharp object to remove the battery.
• Do not disassemble, puncture, or damage the battery.
• Do not swallow, touch, or inhale the contents of an open
battery. Avoid contact with internal acid. Contact with internal
acid may cause irritation or severe burns. Irritation may occur
to the eyes, respiratory system, and skin. Flush with water at
once if contact is made with acid.
• Do not submerge the battery and avoid contact with water.
• Do not short the battery terminals.
• Do not drop or throw the battery.
• Keep the battery away from children.
• Only replace the battery with the correct replacement battery.
Using another battery presents a risk of fire or explosion of
the device or charger.
• Only charge the battery with the included charger.
• Do not charge the battery in an unventilated area.
• Store in a cool, dry, and well-ventilated area.
• Do not charge the battery in a gas-tight container.
• Do not leave the device exposed to a heat source or in
a high-temperature location, such as in the sun in an
unattended vehicle. To prevent damage, remove the device
from the vehicle or store it out of direct sunlight.
• Do not use organic solvents or other cleaners other than
recommended chemical cleaners on the battery.
• Contact your local waste disposal department to dispose of
the battery in accordance with applicable local laws and
regulations.
Charging the Battery
Ensure that you connect the correct connector to the correct
battery terminal. Damage to the battery, device, or bodily harm
may occur if the device is improperly connected to the battery.
Before you can charge the battery using the charger, you must
disconnect the echo device power cable from the positive and
negative terminals on the battery.
WARNING
CAUTION
3