Portable Echo™ Kit Instructions - Garmin Portable echo Manual De Instrucciones

Portable echo™ Kit Instructions
See the Important Safety and Product Information guide in the
GPS device product box for product warnings and other
important information.
Assembling the Mount
Before you can assemble the mount, ensure you have a Phillips
screwdriver available to complete the assembly.
1
Insert the handle into the two openings on the portable
mount .
2
Attach the handle to the portable mount using two
M4×0.7×40 screws and M4×7 mm nuts
3
Press the M6×1 nut into the bottom of the swivel-mount
base .
4
Place the swivel-mount base on the portable mount, route
the echo device power and transducer cables through the
pass-through holes , and fasten the swivel-mount base
using three M4×0.7×10 screws
5
Place the swivel mount
6
Install the M6×1.0 screw
tighten to the preferred position.
2
WARNING
.
.
on the swivel-mount base.
through the swivel-mount, and
7
If necessary, pull out enough slack from the power and
transducer cables so the mount can fully swivel to the
preferred positions when the cables are connected.
Transducer
The transducer can be configured two ways. You can configure
the transducer with the included suction cup mount for use on
the side or bottom of your boat. You can also configure the
transducer with the included float for ice-fishing or dockside use.
Floating the Transducer
1
While holding the transducer arm in one hand, take a length
of the transducer cable and make a loop.
2 Insert the loop into one end of the float until the loop extends
out of the opposite end of the float.
3
Ensure the length of cable between the float and transducer
is long enough so the transducer can be suspended below
the water or ice.
4
Thread the transducer through the loop at the end of float
and pull tight.
Mounting the Transducer with the Suction Cup
If you purchased the echo device separately from the portable
kit, before you can mount the transducer on the transducer arm,
you must find the spacers and washers that were packaged with
the echo device.
1
Attach the suction cup
1/4-20×0.750 screw .
2
Insert the rubber washer and spacer
3
Pull the transducer cable back and slide the transducer into
the transducer arm.
You can route the transducer cable through the notch and
opening in the transducer arm.
4 Place the washers on the outside of the transducer arm.
to the transducer arm using the
into the transducer.