Troubleshooting - Worx WG719 Manual De Instrucciones

TROUBLE SHOOTING
PROBLEM
1. Mower doesn't run
when operation bail is
activated.
2. Motor stops while
mowing.
3. Mower runs but
cutting performance is
unsatisfactory, or does
not cut entire lawn.
4. Mower is too hard to
push.
5. Mower is abnormally
noisy and vibrates.
16
6. Mower not picking up
clippings with the Grass
Collection Bag.
7. When mulching there
are clippings visible.
13AMP Electric Lawn Mower
Release switch lever to turn mower off. Remove safety key, turn
mower over and check that blade is free to turn. If not free, return
to an authorized servicer. Blade should turn freely.
A. Release switch lever to turn mower off. Remove safety key, turn
mower over and check that blade is free to turn. If not free, return
to an authorized servicer. Blade should turn freely.
B. Raise cutting height of wheels to highest position and start
mower.
C. Avoid overloading the mower. Slow down the cutting pace by
pushing mower slower or raise the cut height. Or both.
A. Release operating bail to turn mower off. Turn mower over and
check: Blade for sharpness - Keep blade sharp. Deck and discharge
chute for clogging.
B. Wheel height adjustment may be set too low for grass
condition. Raise cutting height.
A. Raise cutting height to reduce deck drag on grass. Check each
wheel for free rotation.
A. Release operating bail to turn mower off. Turn mower on side
and check blade to ensure it has not been bent or damaged.
If blade is damaged, replace with a replacement blade. If the
underside of the deck is damaged return mower to an Authorized
service center.
B. If there is no visible damage to the blade and the mower still
vibrates: Release switch lever to turn mower off, remove blade.
Rotate blade 180 degrees and retighten. If mower still vibrates,
return the mower to an authorized service center.
A. Remove mulch plate when bagging.
B. Chute clogged. Release operating bail to turn mower off. Clear
chute of grass clippings.
C. Too much cut grass. Raise cutting height of wheels to shorten
length of the cut.
D. Bag full. Empty bag more often.
A. Too much cut grass. Raise cutting height of wheels to shorten
length of the cut. Do not cut off more than 1/3 of total length.
B. Check blade for sharpness. Always keep blade sharp.
SOLUTION
EN