Worx WG719 Manual De Instrucciones página 15

tapping the tool on the ground. This can
damage the unit. Keep hands clear of blade
when cleaning.
MAINTENANCE
WARNING: Stop the mower and
unplug the tool before performing
any maintenance.
NOTE: To ensure long and reliable service,
perform the following maintenance
procedures regularly. Check for obvious
defects such as a loose, dislodged or a
damaged blade, loose fittings, and worn
or damaged components. Check that the
covers and guards are all undamaged and
are correctly attached to mower. Carry out
any necessary maintenance or repairs before
operating mower. If the mower should
happen to fail despite regular maintenance,
please call our customer helpline for
advice1-866-354-9679.
BLADE (17) SHARPENING
KEEP BLADE SHARP FOR BEST MOWER
PERFORMANCE. A DULL BLADE DOES NOT
CUT GRASS CLEANLY OR MULCH PROPERLY.
WEAR PROPER EYE PROTECTION WHILE
REMOVING, SHARPENING, AND INSTALLING
BLADE.
Sharpening the blade twice during a mowing
season is usually sufficient under normal
circumstances. Sand causes the blade to dull
quickly. If your lawn has sandy soil, more
frequent sharpening may be required.
Replace bent or damaged blade immediately.
WHEN SHARPENING THE BLADE(See Fig. J)
1. Make sure blade remains balanced.
2. Sharpen blade at the original cutting
angle.
3. Sharpen cutting edges on both ends of
blade to keep it balanced, removing equal
amounts of material from both ends.
NOTE: 1. Be sure the mower is turned off and
unplugged.
2. Place the mower in stand up storage mode.
BLADE BALANCING (See Fig. K)
Check balance of blade by placing center
13AMP Electric Lawn Mower
hole in blade K-1 over a nail or screwdriver
shank K-2, clamped horizontally in a vise K-3.
If either end of the blade rotates downward,
file that end. Blade is properly balanced when
neither end drops.
BLADE MAINTENANCE (See Fig. L1, L2)
Replace your metal Blade (17) after 50 hours
mowing or 2 years, which ever is the sooner-
regardless of condition.
Follow these procedures to remove and
replace the Blade. You will need garden
gloves (not provided) and a spanner wrench
(provided) to remove the Blade. Hold the
Blade and unscrew the Blade Bolt (15)
counter-clockwise using a spanner wrench,
and then remove the Blade.
To re-assemble, position the Blade with the
cutting edges towards the ground. Then
securely tighten the Blade Bolt.
STORAGE: (See Fig. I1 I2 )
Stop the mower and unplug the tool.
Clean the exterior of the machine thoroughly
using a soft brush and cloth. Do not use water,
solvents or polishes. Remove all grass and
debris, especially from the ventilation slots.
Turn the machine on its side and clean the
blade area. If grass cuttings are compacted
in the blade area, remove with a wooden or
plastic implement.
Store the machine in a dry place. Do not place
other objects on top of the machine.
To aid storage, release the handle cam lever,
and rotate or fold the upper handle.
Ensure cables are not stuck or entangled
when folding or unfolding upper handles. do
not drop the handles.
15
EN