Set Up & Use Of Your Wheelchair - Ki Mobility Catalyst 5 Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
Q. Catalyst Recline Back
Moving Recline System Along Rear Frame
WARNING: Remove patient from wheelchair prior to making this adjustment. Failure to do so
could result in death or serious injury.
1. Depending on where the mounting plates are installed on the frame, you can adjust the
reclining backrest as follows along the rear frame: 1" shorter, 2" shorter or 2" deeper.
2. Using a 4mm Allen wrench and a 10mm wrench, remove flat head cap screws (Fig. 27:A), half
saddles (Fig. 27:B) and M6 nylock hex nuts (Fig. 27:C).
3. Move assembly to desired location along rear frame.
4. Replace the saddles in between plate and rear side frame (Fig. 27:B), reinsert the flat head cap
screws (Fig. 27:A) and replace and tighten M6 nylock hex nuts (Fig. 27:C) until securely
fastened.
5. Repeat on opposite side.
B
C
B
30
Fig. 27
A