Flip Back Height Adjustable T-Arm - Ki Mobility Catalyst 5 Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
F. Flip Back Height Adjustable T-Arm
Use
1. To flip back the armrest, pull the release lever (Fig. 5:A) up and lift the armrest assembly up
and back.
2. To return the armrest down, lower the armrest assembly until the release lever locks back into
place.
A
To Increase/Decrease the Front End Length of Armrest
1. Pull the height adjustment lever (Fig. 6:A) and remove the
upper T-Arm assembly (Fig. 6:B).
2. Rotate the upper T-Arm assembly and reinstall into the
armrest.
3. Close the height adjustment lever (Fig. 6:A) to secure.
NOTE: The armrest pad is not centered on the tube,
widthwise or lengthwise. This offers two different length
options - longer or shorter on the front end of the chair.
This also offers two options with the armrest pad. When
the long end of the armrest is on the front end of chair, the
amrest pad hangs more to the outside of the chair. The
armrest pad hangs more to the inside of the chair when the
short end of pad is on the front end of chair. The armrests
can also be switched to the opposite sides to allow more
options regarding the amount of front end pad length and
side pad length.
To Increase/Decrease the Height of the Armrest
1. Pull the height adjustment lever (Fig. 7:A) and slide the
upper T-Arm assembly to desired height.
NOTE: Each hole on the upper T-Arm assembly bar
represents a height setting that can be used in ½"
increments.
2. Close the height adjustment lever (Fig. 7:A) to secure.
Fig. 6
Fig. 7
A
20
Loosen or tighten this
screw to decrease or
increase tension when
flipping armrest
assembly.
A
Fig. 5
B