General Safety Information; List Of Warnings; Use Instructions And Limitations - Macurco CD-6B Instrucciones Del Usuario

Macurco CD-6B Manual (Rev-1.0) Eng

1 General Safety Information

The following instructions are intended to serve as a general guideline for the use of the Macurco CD-6B Carbon
Dioxide Detector. This manual is not to be considered all-inclusive, nor is it intended to replace the policy and
procedures for your facility. If you have any doubts about the applicability of the equipment to your situation,
consult an industrial hygienist or call Technical Support at 1-844-325-3050.

1.1 List of warnings

Each person using this equipment must read and understand the information in this user manual
before use. Use of this equipment by untrained or unqualified persons or use that is not in
accordance with this user manual, may adversely affect product performance.
Use only for monitoring the gas which the sensor and monitor is designed to detect. Failure to do
so may result in exposures to gases not detectable and cause serious injury or death. For proper
use, see supervisor or user manual, or contact Technical Support at 1-844-325-3050.
This equipment may not function effectively below 32°F or above 122°F (0°C or above 50°C). Using
the detector outside of this temperature range may adversely affect product performance.
This detector helps monitor for the presence and concentration level of a certain specified airborne
gas. Misuse may produce an inaccurate reading, which means that higher levels of the gas being
monitored may be present and could result in overexposure and cause serious injury or death. For
proper use, see supervisor or User manual, or contact Technical Support at 1-844-325-3050.
Do not disassemble unit or attempt to repair or modify any component of this instrument. This
instrument contains no user serviceable parts, and substitution of components may impair product
performance.
Using a certified gas with a concentration other than the one listed for this detector when
conducting a calibration verification test (bump test) or calibration will produce inaccurate
readings. This means that higher levels of the gas being monitored may be present and could result
in overexposure. For proper use, see supervisor or User manual, or contact Technical Support at 1-
844-325-3050.
The following steps must be performed when conducting a calibration verification test (bump test)
or calibration to ensure proper performance of the monitor. Failure to do so may adversely affect
product performance.
• When performing a calibration verification test (bump test) and calibration only use
certified calibration gas at the required concentration level.
• Do not test with expired calibration gas.
Do not cover or obstruct display or visual alarm cover.
•
• Ensure sensor inlets are unobstructed and are free of debris
Failure to follow instructions outlined in this user manual can result in sickness or death.

2 Use Instructions and Limitations

The Macurco CD-6B is a three relay Carbon Dioxide (CO
voltage.
The CD-6B has three selectable alarm relays, buzzer, and digital display options.
REV – 1.0
WARNING
) detector, controller, and transducer available in low
2
[34-2900-0510-2 ] 4 | P a g e