Haier ESD200 Manual Del Usuario página 30

Dishwasher will not fill:
• Check thewater
supply.
Make sure that the water supply is in "ON" position.
• Check water pressure.
Make sure the water pressure is at the proper level. (Between 20 - 120 PSI)
Water found under the filter:
• A small amount of water found under the filter area after completion of the cycle
is normal.
Detergent found in the compartment:
• Do not load itemstoo closeto the detergent compartment. This may block the
automatic release of the detergent.
• Do not use old or caked/dried detergent in the compartment because it will not
dissolve properly and will leave a sandy residueon dishware.
Dishwasher is running for too long:
• The temperature of incoming water is below 120°F. Raising your water heater
settingwill help to shortenthe time of operation.
• Call the Haier CustomerSatisfactionCenter if this does not resolve the problem.
Beeping Sound and Flashing Light(s):
• The dishwasher door is not closed properly.
After pressing the "START/PAUSE" button to start the wash processand if the
door is not closed properly or the door is opened in the middle of the wash
process, you will notice the following,
- The 1st light from the left of "Wash Programs Indicator Lights"will flash.
- The machine will continueto beep every few seconds.
• Close the door properly. The machine will stop beeping. The selected wash
program light will flash and the wash processbegins automatically.
• If the dishwasher malfunctionsin the middle of the wash operation, the "Wash
Programs Indicator Lights"will flash and the machine will beep.
29