Filling The Water Tanks; Operation - Siemens pureFlow DW03500 Serie Instrucciones De Empleo

Risk of scalding!
After connection to the coupling (27b), hot water
immediately runs out of the drainage hose (28).
Attach the angled end of the drainage hose (28)
■
to the coupling (27b) and release the hot water
from the tank into the basin prepared for this
purpose.
Remove the drainage hose (28) and close the
■
opening with the red safety lock cap (27a).
Slide the sliding door (27) upward.
■
Remove the collection tray with drip grate (26),
■
then empty and rinse it.

Filling the water tanks

Open the water supply again. Insert the appli-
■
ance's electrical plug in the electrical socket and
switch the On/Off switch (14) to I.
Press and hold the selection button
■
water) for approx. 3 seconds to switch on the
cold water function.
It will take about 2 hours until all three tanks are
refilled.
Drain the tanks once more and then refill as de-
■
scribed in Chapter "Draining the water tanks" and
"Filling the water tanks".
The appliance is ready to operate when both LED in-
dicators "Hot water" (17) and "Cold water" (18) light
up completely.
LED Hot water
34
en
(Cold
LED Cold water

Operation

Important
The appliance must be connected and switched on.
By pressing the corresponding button, you can
easily select between
Hot water
Ambient water
Cold water
Press the desired water temperature button, e. g.
■
the selection button
Now, set a glass under the water outlet.
■
Press the dispensing
■
Water flows into the glass.
(Cold water).
button.