Idiomas disponibles
Idiomas disponibles
5–
Pyramid adapter adjustment
Changing the orientation of the pyramid or replacing adapter
1K60 by adapter 1K66.
Loosen or remove the adapter. Adjust its orientation, then
reassemble or retighten it and apply thread locking
adhesive on the threads of the lower adapter. Tighten to
torque 6 Nm.
6-
Maintenance.
Spare kit for the sole and the underlayer :
2 colors are available :
Product Nr 1A92013-1 (green) or 1A92013-2 (black).
Take off the sole and clean the side to be sticked (do not use a solvent
because this would damage the appearance of the short blade).
Sand the sides manually before sticking the underlayer
on the short blade. Do the same to stick the sole on the
underlayer (with neoprene adhesive XC090).
7-
Advice for use, maintenance and safety
The product should be assembled only to the authorized prosthetic components mentionned in paragraph
« 2 -
Indications, maximum weight, adapter».
The instructions for maximum weight and activity (running, jogging) when using the product should be respected.
There are specific risks due to lower limb amputation (patient falling, trophic disorders of the residual limb caused by the
prosthesis socket, ...). For these reasons, the patient must be trained to running by a CPO or a physiotherapist, or in a
disabled sports club or a rehabilitation center.
Running on a treadmill can be considered under human supervision only and never when the patient is alone.
A use that does not adhere to your supplier's recommendations can damage blade components (carrying heavy loads,
jumping a high height for example).
Do not heat the blade with a hot air gun, do not machine the blade to reduce its section, do not sand the short blade too much
when replacing the sole (risk of removing the upper carbon layer).
Do not cut or drill the blade.
Using temperature : - 10°C / + 40°C.
The presence of sand, particles or any foreign body inside the foot may alter its behaviour and damage it. After use in water or
in a very durty environment : Rinse the blade and the other parts thoroughly with clear water to eliminate particles (mud, sand,
...), then dry the different items.
Clean the blade with a slightly damp cloth or sponge, then dry the different items.
Do not forget to give to the patient the caring instructions sheet.
8-
Recycling
This product includes items made in different materials : Elastomer, composite with epoxy resin, titanium, stainless steel.
These parts should be recycled according to the laws in force.
1A92099-0119 page 6/15
4 x countersunk screw M6
Adapter 1K60 or 1K66
Plate of adapter 1K60 or 1K66
(1mm thick)
Wedging plate 1K05 (2mm thick)
Blade
Lower adapter
