Install The Adapter/Damper - Best UCB3I Serie Instrucciones De Instalación

5. INSTALL THE ADAPTER/DAMPER (

The wall duct must be roughed-in to properly interface with the hood. Before performing the installation, make sure the adapter fits easily
in the duct. If this hood replaces an existing hood, please note that location of the air exhaust can vary from one manufacturer to another.
F H D
OR ORIZONTAL ISCHARGE
Turn the hood over and remove the metal shutoff plate from the back of the hood, by
removing both retaining screws. Set screws aside.
Press the metal shutoff plate on a flat surface to completely flatten bent flange.
Using both screws previously removed, install the metal shutoff plate on top of the hood.
Fold down the foldable flange of the adapter/damper. This flange must be at 90° from the
remaining flanges. See picture beside.
Using two no. 6 x 1/2'' screws provided, secure the adapter/damper to the back of the hood.
Remove tape from damper flap.
Seal the adapter/damper to the hood using metal foil duct tape.
F V D O
OR ERTICAL ISCHARGE
Using two no. 6 x 1/2" screws provided, secure the adapter/damper to the top of the hood.
Remove tape from damper flap.
Seal the adapter/damper to the hood using metal foil duct tape.
ALL MODELS
O :
NLY
:
NLY
)
HO0244
HD0415
HO0245
HD0112
P
IVOT
HO0178
P
IVOT
HO0179
6
S
CREW LOCATIONS
T
OP
B
OTTOM
S
CREWS