How To Turn The Power On And Off; Turning The Power On - Panasonic AW‑HE50HE Instrucciones De Uso

How to turn the power on and off

w Turning the power on
w
When performing the operations
using the wireless remote control
1
Set all the power switches of the units and
devices connected in the system to ON.
w p This unit does not have a power switch.
When power is supplied to it, the status display lamp
will light up orange.
The initial operation is then performed, and after this
the unit is set to the standby mode.
2
Press one of the [CAM1] to [CAM4] buttons on
the wireless remote control to select the unit.
3
Press the [ON/STANDBY] button on the
wireless remote control for 2 seconds.
The POWER ON mode is established, images are
output, and control can be exercised.
w p The unit's status display lamp now lights up green.
Notes
w p It takes about 30 seconds per unit for the initial
settings operation to be completed. During this
period, the unit cannot be operated.
(Status display lamp: light up orange)
w p When operation is transferred to the standby
mode: The current pan‑tilt position is stored in
the memory (as a POWER ON preset), and the
panning/tilting moves so that the camera points in
the backward‑facing direction.
w p When operation is transferred to the POWER ON
mode: Panning/tilting moves to the position which
was stored in the memory (as a POWER ON
preset) when operation was transferred to the
standby mode.
4
If a multiple number of units are going to be
used, repeat steps 2
The unit's status display lamp blinks green when a signal
matched by the remote control ID has been received, and
it blinks orange when a signal that is not matched by the
remote control ID has been received.
and 3 as required.
When performing the operations using the controller
When the AW‑RP655 or AW‑RP555 is connected:
1
Set all the power switches of the units and
devices connected in the system to ON.
w p This unit does not have a power switch.
When power is supplied to it, the status display lamp
will light up orange.
The initial operation is then performed, and after this
the unit is set to the standby mode.
2
Set the [OPERATE] switch on the controller to
ON.
The POWER ON mode is established, images are
output, and control can be exercised.
w p The unit's status display lamp now lights up green.
Notes
w p It takes about 30 seconds per unit for the initial
settings operation to be completed. During this
period, the unit cannot be operated.
(Status display lamp: light up orange)
w p When operation is transferred to the standby
mode: The current pan‑tilt position is stored in
the memory (as a POWER ON preset), and the
panning/tilting moves so that the camera points in
the backward‑facing direction.
w p When operation is transferred to the POWER ON
mode: Panning/tilting moves to the position which
was stored in the memory (as a POWER ON
preset) when operation was transferred to the
standby mode.
Before setting the [OPERATE] switch on the controller to
ON, be absolutely sure to set all the power switches of the
units and devices connected in the system to ON.
For further details, refer to the Operating Instructions of the
controller.
When the AW‑RP50 is connected:
Refer to the Operating Instructions of the controller.
6 (E)