Status / Alarm Codes - GMP GM 360 PRO Manual Del Usario

S /
TATUS ALARM CODES
Using a sophisticated self-diagnosis system, the UPS is able to check and signal its own status and any anomalies or faults
which may occur during normal operation. If there is a problem, the UPS signals the event by showing the code and the type of
active alarm on the display.
 STATUS: indicates current UPS status.
CODE
S01
S02
S03
S04
S05
S06
S07
S08
S09
S10
S11
S12
S13
 COMMAND: indicates presence of an active command.
CODE
C01
C02
C03
C04
C05
C06
C07
C08
 WARNING: these messages relate to a special UPS configuration or operation.
CODE
W01
W02
W03
W04
W05
104
DESCRIPTION
Pre-loading in progress
Load not powered (stand-by status)
Start-up phase
Load powered by bypass line
Load powered by inverter
Battery operating mode
Waiting for battery charging
Economy mode on
Ready for start-up
UPS locked – load not powered
UPS locked – load on bypass
BOOST stage or battery charger locked – load not powered
Frequency converter - load powered by inverter
DESCRIPTION
Remote power-off command
Remote load command on bypass
Remote power-on command
Battery test in progress
Manual bypass command
Emergency power-off command
Remote battery charger power-off command
Load command on bypass
DESCRIPTION
Low battery warning
Programmed shutdown on
Programmed shutdown imminent
Bypass disabled
Synchronization disabled (UPS in Free running)