Sony SU-WL31 Instrucciones página 10

3
Adjust the angle of the stabilizer
arms.
When installing the TV perpendicularly (0
degrees), adjustment of the arms angle (step 1
and 2 below) is not necessary. Make sure that
each stabilizer arm is screwed in securely.
1 Remove all four angle adjust screws.
2 Put them into the screw holes corresponding
to the desired angle (5, 10, 15 or 20 degrees)
and tighten them firmly.
Notes
• Be sure to adjust the angles of the right and left
arms to the same angle.
• Be careful not to pinch your fingers when adjusting
the angle of arms.
• When using an electric screwdriver, set the torque
setting to approximately 2 N·m {20 Kgf·cm}.
• Make sure that four arm bases are screwed in
securely.
Notes on the adjustment angles
• When installing TV or monitor models other
than those specified on page 2 (depending on
the model's size and dimensions, etc.), the
adjustment angles listed (0, 5, 10, 15, 20
degrees) for the stabilizer arms may be limited.
• For the available adjustment angles of the
stabilizer arms when installing TV or monitor
models other than those specified on page 2,
refer to the operating instructions or the leaflet
("Installing the Wall-Mount Bracket") supplied
with the TV or monitor.
Stabilizer arm
1
Angle adjust
screw
Arm Bases A
and B
10
(GB)
2
Step 5:
Preparing for the
installation of the TV
The procedure differs depending on
the TV. Apply the procedure
appropriate for the TV you are
installing.
KDL-V32A1s*/KLV-V32A1s*/
KDL-V32XBR1 ............................................ A
KDL-V26A1s*/KLV-V26A1s*/
KDL-V26XBR1 ............................................ B
KDL-S32A1s*/KLV-S32A1s* ................... C
KDL-S26A1s*/KLV-S26A1s* ................... D
KDL-S23A1s*/KLV-S23A1s* ................... E
* In the actual model names, the "s" indicates numbers
and/or characters specific to each model.
1
Detach the Table-Top Stand from
the TV.
1 Place the TV, with its screen facing down, on
a stable, cloth-covered work surface.
ABCDE
Soft cloth