Proper Use; Safety Instructions; Safety Devices; Start Up - Kärcher HDS 6/14 C Classic Manual Del Usuario

Proper use

Cleaning of: Machines, Vehicles, Struc-
tures, Tools, Facades, Terraces, Garden-
ing tools, etc.
Danger
Risk of injury! Follow the respective safety
regulations when operating at gas stations
or other dangerous areas.
Please do not let mineral oil contaminat-
ed waste water reach soil, water or the
sewage system. Perform engine cleaning
and bottom cleaning therefore only on
specified places with an oil trap.

Safety instructions

Please follow the national rules and
–
regulations for fuel spray jets of the re-
spective country.
Please follow the national rules and
–
regulations for accident prevention of
the respective country. Fuel spray jets
must be tested regularly and the results
of these tests must be documented in
writing.
The heating appliance of the machine is
–
an ignition plant. All national laws and
regulations about heating systems must
also be followed.

Safety Devices

Safety devices serve for the protection of the
user and must not be put out of operation or
bypassed with respect to their function.
Pressure switch
The pressure switch turns the device off
–
when the handgun is closed and switch
on when the handgun is opened.
Safety valve
The safety valve opens, when the over-
–
flow valve resp. the pressure switch is
broken.
The safety valve is set by the manufacturer
and sealed. Setting only by customer ser-
vice.
18
Water shortage safeguard
The water shortage safeguard prevents
–
the burner to be turned on when there is
water shortage.
A sieve prevents the contamination of
–
the safeguard and must be cleaned reg-
ular.
Temperature stop for exhaust gases
The temperature stop switches off the
–
machine when the waste gases have
reached very high temperatures.
Warning
Risk of injury! Device, tubes, high pressure
hose and connections must be in faultless
condition. Otherwise, the appliance must
not be used.
 Lock parking brake.
Installing the handle
Figure 3
Screw tightening torque: 6.5-7.0 Nm
Install the tool bag
Figure 4
 Hook the tool bag onto the top tabs on
the appliance.
 Tilt the tool bag down and lock it into
place.
 Fasten the tool bag with 2 screws
(torque: 6.5 - 7.0 Nm).
Install the hand-spray gun, the jet
pipe, the nozzle and the high pres-
Figure 5
 Connect ray tube with hand spray gun
 Tighten the screw connection of the
spray lance finger tight.
 Insert high pressure nozzle into cover-
ing nut
 Install covering nut and tighten firmly
 Connect the high pressure hose to the
high pressure connection point of the
machine.
– 3
EN

Start up

sure hose