Warnings; Cautions - Maxtec MaxFLO2 Manual De Instrucciones E Instrucciones De Uso

WARNINGS

Indicates a potentially hazardous situation which, if not avoided, could result in
death or serious injury.
DO NOT use the MaxFLO
DO NOT use the MaxFLO
• The MaxFLO
2
source or a drop of gas pressure below functional levels (25 PSI) is determined
visually by monitoring individual gas flows.
DO NOT use the MaxFLO
pressurized gas. The MaxFLO
DO NOT use the MaxFLO
• The MaxFLO
2
• Always operate the MaxFLO
moisture can cause defective operation. Oxygen should have a minimum dew point
of -80°F (-62°C) or moisture content less than 7.9 ppm (0.0059 mg/L). Oxygen
"purity" should be at least 99.6% and air used should be medical grade. Water
vapor content must not exceed a dew point of 5°F (-15°C) below the lowest ambient
temperature to which the delivery system is exposed. Particulate content must not
exceed that which would be found immediately downstream of a 15 micron absolute
filter. Refer to CGA commodity specifications G4.3 and G7.1 for more information.
Water vapor content of medical air or oxygen supply to the MaxFLO
5.63 x 103 mg/m3 H
• The MaxFLO
2
healthcare professional.
• Consult a physician for appropriate FiO
• The oxygen concentration selection table in this operating manual is provided only as
a guideline for selecting oxygen concentration. Verify oxygen concentrations using an
analyzer/monitor which can be calibrated.
DO NOT autoclave or expose the MaxFLO
DO NOT use ethylene oxide sterilization.
DO NOT expose the MaxFLO
DO NOT disconnect gas hoses from the MaxFLO

CAUTIONS

Indicates a potentially hazardous situation which, if not avoided, could result in
minor or moderate injury and property damage.
• Use caution when using the MaxFLO
an atmosphere of flammable gases when the O
recommends following hospital anesthetic gas guidelines*.
• Before use on a patient, the oxygen concentration of the delivered gas should be
checked at the setting intended for use.
• The MaxFLO
2
intermittent gas analysis. Maxtec recommends use of an oxygen analyzer/monitor,
which can be calibrated, whenever the MaxFLO
• Use caution when using the Mixed Gas Analysis Port to ensure the analyzer/
monitor does not become unintentionally or accidentally dislodged. The MaxFLO
optimized for use with flow diverters from Maxtec analyzers/monitors.
Do not insert flow diverters into the Mixed Gas Analysis port which are not connected
to an analyzer/monitor.
II
!
in an MRI environment.
2
as a life support device.
2
DOES NOT CONTAIN AUDIBLE OR VISUAL ALARMS. Loss of a gas
to provide mixed gas to other devices which require a
2
DOES NOT SUPPLY A PRESSURIZED GAS MIXTURE.
2
near any type of open flame.
2
is only for use with oxygen and medical air.
with clean, dry medical grade gases. Contaminates or
2
O of non-condensable gas.
2
should only be used under proper supervision from a
to pressures greater than 100 PSI.
2
is designed for use with a gas analyzer/monitor for continuous or
866.4.Maxtec
settings.
2
to high temperatures (>65°C).
2
while the device is under pressure.
2
in the presence of flammable anesthetics or in
2
concentration exceeds 30%. Maxtec
2
is in use.
2
www.maxtec.com
must not exceed
2
is
2