Temperature Effect; Pressure Effect; Humidity Effect; Spare Parts And Accessories - Maxtec MaxFLO2 Manual De Instrucciones E Instrucciones De Uso

9.2 Temperature Effect

Readings from an oxygen analyzer/monitor will typically hold calibration and read
correctly within ± 2% when in thermal equilibrium with their operating environment.
Use caution to ensure the oxygen analyzer/monitor is thermally stable when calibrated
to ensure optimal performance and accurate readings by the analyzer/monitor. Maxtec
recommends the following:
• Allow adequate time for the sensor to equilibrate to a new ambient temperature.
• For best results, perform the calibration procedure at a temperature close to the
temperature where analysis will occur.

9.3 Pressure Effect

Readings from an oxygen analyzer/monitor are proportional to the partial pressure
of oxygen. The partial pressure is proportional to the absolute pressure at any given
concentration. Thus the readings are proportional to the concentration if the pressure
is held constant. Flow rate of a gas can affect the sensor calibration due to a change in
pressure. Maxtec recommends the following:
• Calibrate analyzers/monitors used with the MaxFLO
possible as during normal operating conditions.

9.4 Humidity Effect

Humidity (non-condensing) has no effect on the performance of the MaxFLO
than diluting the gas.
• Use caution to avoid condensing humidity when in operation.

10.0 SPARE PARTS AND ACCESSORIES

10.1 Included with Your Unit

Part Number:
R223P01
R219P31
R110P10-001
R223M01

10.2 Spare Parts

Part Number:
R110P10-001
R219P31
R219P33
R219P33-002

10.3 Optional Accessories

Part Number:
R217P62
R217P72
R213P10
R213P05
R125P03-002
R129P12
R100P49-001
R206P75
* An electronic version of this Operating Manual and Instructions for Use is available on-line at
www.maxtec.com
8
Item:
MaxFLO , Low Flow
2
22mm Male/15mm Female Conical Fitting, Low Flow
Flow Diverter
Operating Manual and Instructions for Use (English)*
Flow Diverter
22mm Male/15mm Female Conical Fitting, Low Flow
Low Flow Valve Replacement Kit
Low Flow Overhaul Kit
Item:
+ A (Handheld Oxygen Analyzer)
MaxO
2
+ AE (Handheld Oxygen Analyzer)
MaxO
2
OM-25AE (Oxygen Analyzer)
OM-25ME (Oxygen Monitor)
MAX-250E (Oxygen Sensor Medical)
2' Blender Hose
SmartStack I.V. Stand (Single, Premium)
Pole Mount (For use with Analyzers/Monitors with external sensors)
866.4.Maxtec
at as close to the same flow as
2
www.maxtec.com
other
2