Idiomas disponibles
Idiomas disponibles
Gas Requirements
For Natural Gas Connection
Preparing:
1.
Turn off gas supply, and then remove cap on gas
Supply side.
2.
Recommended: Install a shut-off valve on
gas supply side before installing the socket.
3.
Socket should be installed by an authorized
technician in accordance
with the national fuel gas
code (NFPA 54/ANSI223.1)
4.
Before inserting plug, turn on gas supply and leak
test all connections including the stem of the shut-off
valve and the opening of the socket. For best results,
use and ammonia-free soap & water solution.
Operating
Instructions:
1.To connect, push back socket sleeve.
Socket
Sleeve
Plug
LP Gas
If your grill is for LPGas, the regulator supplied is set for
an U-in. Water column (WC) and is for use with LP gas
only. The factory-supplied
regulator and hose must be
used with a 20-lb. LPgas tank.
Natural
Gas
If your grill is for Natural Gas, it is set for a 7-in. water
column (WC) and is for use with Natural Gas only. Gas
pressure is affected by gas line size and the length of
gas
line
run from
house
gas
line.
Follow
the
recommendations in the chart below.
From House to Grill
Distance
Tubing Size
Up to 25 ft.
3/'8 in. diameter
26-50 ft.
1/2 in. diameter
5H00
if,
2/3 of the run: 3/4 in. diameter
1/'3 of the run: 1/2 in, diameter
Over 101 ft.
3/4 in. dia_ter
2. Insert plug and release sleeve.
3. Pushplug until sleeve snaps forward.
(Gas will flow
automatically. Failure to connect plug properly to
socket will inhibit gas flow to the appliance.)
To disconnect
1.
Pull Sleeve back. Pull plug out socket. (Gas is
automatically
shut off.)
2.
Close shut-off valve and replace dust caps on socket
and plug.
14 ° 33577-41500319
