Art-Net™ Source (Art-Net™ Adapter) - Chauvet Professional Net-X Manual De Usuario

Configuration And Operation
Art-Net™ Source (Art-Net™ adapter)
Art-Net™ source-only configuration uses the Net-X™ as an Art-Net™-to-DMX adapter. The
signal comes in from the Art-Net™ source to the Neutrik® etherCON® port and goes out
through one or more of the DMX Out ports. To configure the Net-X™ as an Art-Net™-to-DMX
adapter with the addresses and DMX Out port assignments listed here:
· Net setting of 3
· Subnet setting of 7
· IP addresses of 10.255.255.009 and 10.255.255.011
· Art-Net™ universe 4 going to DMX Out port 1
· Art-Net™ universe 8 going to DMX Out port 2
Do the following:
1. Set the Net address to 3 by doing the following:
a) Press <MENU> repeatedly until <Net> shows in the display.
b) Press <ENTER>. The number in the lower right-hand corner of the display
c) Press <UP> or <DOWN> until 3 shows.
d) Press <ENTER>.
2. Set the Subnet address to 7 by doing the following:
a) Press <MENU> repeatedly until <Subnet> shows in the display.
b) Press <ENTER>. The number in the lower right-hand corner of the display
c) Press <UP> or <DOWN> until 7 shows.
d) Press <ENTER>.
3. Set the IP addresses by doing the following:
a) Press <MENU> repeatedly until <IP Address #1> shows in the display.
b) Press <ENTER>. The left-most set of 3 digits on the display flashes.
c) Press <UP> or <DOWN> until those numbers show 255.
d) Press <ENTER>.The next set of 3 digits on the display flashes.
e) Press <UP> or <DOWN> until those numbers show 255.
f) Press <ENTER>.The right-most set of 3 digits on the display flashes.
g) Press <UP> or <DOWN> until those numbers show 009.
h) Press <ENTER>.
i) Press <MENU> repeatedly until <IP Address #2> shows in the display.
j) Press <ENTER>. The left-most set of 3 digits on the display flashes.
k) Press <UP> or <DOWN> until those numbers show 255.
l) Press <ENTER>.The next set of 3 digits on the display flashes.
m) Press <UP> or <DOWN> until those numbers show 255.
n) Press <ENTER>.The right-most set of 3 digits on the display flashes.
o) Press <UP> or <DOWN> until those numbers show 011.
p) Press <MENU>.
4. Disable the unused DMX Out ports by doing the following for DMX Out ports 3 to 8:
a) Press <MENU> repeatedly until <DMX Output Port #X> shows on the display.
b) Press <ENTER>. The phrase in the lower right-hand corner of the display
Page 16 of
flashes.
flashes.
flashes.
Net-X™ User Manual Rev. 2