Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Menu Map
The menu map shows the organization of the configuration settings. Use it for reference
when configuring the Net-X™.
Main Function
<Net>
<Subnet>
<Universe #1> to
<Universe #8>
<DMX Output #1> to
<DMX Output #8>
<IP Address #1>
<IP Address #2>
<Device ID>
Using The Menu
The menu is used by pressing the 4 control buttons as described in the next sections.
Configuring Net Address
The Net is the address of the network on which the Net-X™ is operating. The Net address
must be configured if the Net-X™ is being used as an Art-Net™ hub.
To configure the Net setting, do the following:
1. Press <MENU> repeatedly until <Net> shows in the display.
2. Press <ENTER>. The number in the lower right-hand corner of the display flashes.
3. Press <UP> or <DOWN> until the desired Net shows.
4. Press <ENTER>.
Configuring Subnet Address
The Subnet is the address of the subnet of the network on which the Net-X™ is operating.
The Subnet address must be configured if the Net-X™ is being used as an Art-Net™ hub.
To configure the Subnet setting, do the following:
1. Press <MENU> repeatedly until <Subnet> shows in the display.
2. Press <ENTER>. The number in the lower right-hand corner of the display flashes.
3. Press <UP> or <DOWN> until the desired Subnet shows.
4. Press <ENTER>.
Net-X™ User Manual Rev. 2
Programming Levels
0–127
Sets the Net address
0–15
Sets the Subnet address
Sets the Art-Net™ universe for the corresponding
0–15
DMX Out port
(only necessary if the DMX port is set to Art-Net™)
ArtNet Input
Input source for each DMX Out port is Art-Net™
DMX #1 Input
Input source for each DMX Out port is DMX In port 1
DMX #2 Input
Input source for each DMX Out port is DMX In port 2
DMX Out port is turned off
Without Input
Sets the two IP addresses for the Net-X™
x.xxx.xxx.xxx
Note: The addresses cannot be the same.
Shows the Net-X™ device ID
xxxxxxxxx
Configuration And Operation
Description
Page 13 of
Tabla de contenido
