Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Mounting
The Net-X™ fits nicely in a standard 19" rack, or sits on a flat surface. The Net-X™ should be
placed where the menu and the ports are accessible, and where there is adequate
ventilation.
Signal Connection
The Net-X™ receives signal though 2 DMX In ports and one of 2 Neutrik® etherCON® ports.
It sends signal out through 8 DMX Out ports and the other Neutrik® etherCON® port.
Signal Connection Diagram
From DMX Sources
The Neutrik® etherCON® ports are through ports. Each port can be either
·
an input or an output port.
·
The DMX ports can only be input or output ports. There are 2 DMX In
ports and 8 DMX Out ports.
Installation Guidelines
The Net-X™ is used as part of a control system for operating various lighting and multi-media
products. The physical and digital construction of the control network is determined by the
location and signal needs of the products.
When designing a control system that uses the Net-X™, consider the following:
· Placing the Net-X™ so the menu and ports can be accessed
· Running the cables so there is no tension or pull on the cables or plugs
· Planning a large control system carefully before configuring the components, so IP
address, DMX address, and other identifiers are not duplicated
Net-X™ User Manual Rev. 2
To Another Net-X™
Or Other Art-Net™ Products
Setup And Installation
From Art-Net™ Sources
To DMX
Controlled
Products
Page 11 of
Tabla de contenido
