Add Engine Oil And Fuel - Craftsman CMXGWAS020737 Manual Del Operario

ENGLISH
Attach Handle and Accessory Tray (Fig.
B, C)
1. Place handle onto handle supports connected
1
to main unit. Make sure holes in handle align with
holes on handle supports.
Fig. B
1
2. Insert handle carriage bolts
inside of unit and attach a plastic knob
outside of unit. Tighten by hand.
NOTICE By loosening both knobs to the middle section
of the attachment bolt, the upper handle can fold
forward to store flat atop the cold engine. DO NOT fold
the handle down while the engine is hot.
3. Place accessory tray
(viewing from front of unit). Push the tree clips
into the holes until they sit flat against the
6
accessory tray.
Fig. C
6
4. Insert supplied accessories in spaces provided in
accessory tray. See How to Use Accessory Tray.
6
3
2
through holes from
2
from
3
over holes on handle
4
5
4

Add Engine Oil and Fuel

• Place pressure washer on a level surface.
NOTICE Any attempt to crank or start the
engine before it has been properly filled with the
recommended oil will result in equipment failure.
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
• Refer to engine operator's manual and follow oil
and fuel recommendations and instructions.
NOTICE Check oil often during engine break–in. Refer
to engine operator's manual for recommendations.
Lubricate O-Rings (Fig. D)
Lubrication of o-rings is extremely important for
installation and operation. The use of a lubricant
(petroleum or synthetic grease) during assembly helps
seat o-rings properly and provides an improved seal. It
also helps protect the o-ring from damage by abrasion,
pinching or cutting and extends the life of the o-ring.
NOTICE ALWAYS apply a small amount of lubricant on
o-rings prior to assembling the garden hose to the pump
, high pressure hose
7
extension .
10
Fig. D
5
Lubricate all connections shown below, following these
instructions:
1. Inspect and clean connecting surfaces prior to
lubrication and assembly.
2. Use lubricants sparingly during assembly; a light
film is all that is required.
3. Use a small brush or cotton swab to apply grease
directly to o-rings where they are not accessible
(QC fitting, M22 fitting).
, spray gun , and nozzle
8 9
9
10
7
8