Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Programming
a Scene or
Scenes
Editing a Scene
or Scenes
Deleting a Scene
or Scenes
Page 16 of 88
The Foot-C has one bank of scenes, separate from the chase banks, for saving and
playing back recorded scenes. To record a scene, follow the instructions below:
1.
Enter program mode.
2.
Press <MODE> until the left display reads SCENE.
3.
Use <UP> and <DOWN> to select the desired scene.
4.
Use buttons <1>–<6> to select the fixture(s) to be programmed.
5.
Use the Color/Number knobs to set the desired output.
6.
Repeat steps 4 and 5 until all fixtures output as desired.
7.
Press <PROGRAM>. The displays will flash, showing the scene was saved.
8.
Repeat steps 3–7 for up to 24 scenes.
9.
Exit program mode.
Scenes are intended to be used for static looks, as opposed to chases which are
intended for changing looks.
After being recorded, any scene can be re-programmed. To edit a scene, do the
following:
1.
Enter program mode.
2.
Press <MODE> until the left display reads SCENE.
3.
Use <UP> and <DOWN> to select the scene to be edited.
4.
Use buttons <1>–<6> to select the fixture(s) to be programmed.
5.
Use the Color/Number knobs to set the desired output.
6.
Repeat steps 4 and 5 until all fixtures output as desired.
7.
Press <PROGRAM>. The displays will flash, showing the scene was saved.
8.
Repeat steps 3–7 for all scenes that require editing.
9.
Exit program mode.
Looks created or edited in program mode will not be stored in the system memory
until <PROGRAM> has been pressed.
To delete a scene, do the following:
1.
Enter program mode.
2.
Press <MODE> until the left display reads SCENE.
3.
Use <UP> and <DOWN> to select the scene to be deleted.
4.
Press and hold <DELETE> for three seconds. The displays will flash, indicating the
scene was deleted.
5.
Release <DELETE>.
6.
Repeat steps 3–5 until all desired scenes have been deleted.
7.
Exit program mode.
Deleted scenes cannot be restored without redesigning the look.
Foot-C User Manual Rev. 2
Tabla de contenido
