Rolled Hem; Cording - Janome Memory Craft 4900 Manual De Instrucciones

Tabla de contenido
q
w
1
q
w
32
e
0.5 cm
0.8 cm
e
q

Rolled hem

Machine settings
q Pattern:
w Presser foot:
e Thread tension:
To sew:
Fold the edge of the fabric twice, 6 cm (2 3/8˝) in length
and 0.3 cm (1/8˝) in width.
Trim the corner 0.5 cm (3/16˝) by 0.8 cm (1/4˝) for easier
insertion of the hem into the foot.
Position the fabric aligning the edge of hem with the guide
on the foot.
Lower the foot and sew 1–2 cm (1/2˝ – 1˝) while pulling
both threads to the back.
Stop the machine with the needle down in the fabric. Raise
the foot and insert the folded portion of the fabric into the
curl of the foot.
Lower the foot, and then sew by lifting up the edge of the
fabric to keep it feeding smoothly and evenly.

Cording

Machine settings
q Pattern:
w Presser foot:
e Thread tension:
Attach the cording foot H
3-strand cording
Insert 3 strands of cording under the spring of the foot and
draw them under the foot to the rear.
Hold the three strands parallel for even sewing and be sure
to sew over the strands
Stitch slowly and smoothly, guiding the fabric as you sew.
q Spring
1-strand cording
Insert 1 strand of cording under the spring of the foot and
draw it under the foot to the rear (use the center slot of the
spring).
Select pattern 8 (mode 1), then decrease the stitch width
and sew.
126
1 (mode 1)
Hemmer foot D
AUTO
32 (mode 2)
Cording foot H
AUTO
Tabla de contenido
loading

Tabla de contenido