Rear Brake Lining Control; Brake Disc Thickness Control - Beta Motorcycles RR 125 LC 2019 Manual De Instrucciones

4

REAR BRAKE LINING CONTROL

To check the wear of the rear brake pads,
visually inspect the caliper from the rear
side. The lining on the visible ends of the
two brake pads should be at least 2 mm
thick. Should the lining be thinner, imme-
diately replace the brake pads.
Note:
Perform the check according to the times
shown in the table on page 60.
To replace, contact authorised Betamotor
2 mm
customer service.
BRAKE DISC THICKNESS
CONTROL
Periodically verify disc condition. In case
signs of damage , veins, or deformations
are present, proceed with replacement.
Verify disc thickness. The minimum thick-
ness is engraved on the disc.
Once the limit is in proximity or has been
reached, proceed with brake disc replace-
ment.
For replacement, contact an authorised
Betamotor after-sales service centre.
EN
46