Tabla de contenido
If the wireless network settings are incorrect, follow these
steps to correct the printer's settings:
1.
Connect the printer to your network with a network
cable or to the computer using the cross cable
included with the printer.
2.
Open the printer's embedded Web server.
3.
Click the Networking tab, and then click Wireless
(802.11) in the left pane.
4.
Use the Wireless Setup wizard on the Wireless Setup
tab to change the printer's settings to match the
settings of the network.
5.
Close the printer's embedded Web server, and then
disconnect the network cable from the printer.
6.
Uninstall the printer software completely, and then
reinstall the software.
Add hardware addresses to a
wireless access point (WAP)
MAC filtering is a security feature in which a wireless
access point (WAP) is configured with a list of MAC
addresses (also called "hardware addresses") of devices
that are allowed to gain access to the network through
the WAP. If the WAP does not have the hardware
address of a device attempting to access the network,
the WAP denies the device access to the network. If the
WAP filters MAC addresses, then the printer's MAC
address must be added to the WAP's list of accepted
MAC addresses.
1.
Press
/
(Configuration Page button) to print
the configuration page.
2.
Open the WAP's configuration utility, and add the
printer's hardware address to the list of accepted
MAC addresses.
Reset network configuration settings
If the printer is still unable to communicate with the
network, reset the printer's network settings.
1.
Press and hold
/
(Configuration Page button),
press
(Resume button) three times, and release
/
(Configuration Page button). The Power
light blinks for a few seconds. Wait till the Power
light is on.
2.
Press
/
(Configuration Page button) to print
the configuration page and verify that the network
settings have been reset. By default, the network
name (SSID) is "hpsetup" and the communication
mode is "ad hoc".
25
Tabla de contenido
Solución de problemas
