Setting Up Anynet; Scanning And Switching Between Anynet + Devices - Samsung HP-T4254 Manual Del Proprietário

Setting Up Anynet +
The following settings are to use Anynet + functions.
To use the Anynet+ Function, Anynet+_HDMl-CEC_ must be set to On
1 Press the Anynet + button.
Press the A or _' button to select Setup, then press the ENTER button.
2 Press the ENTER button to select Anynet+ (HDMI-CEC), then press the
ENTER button.
Press the & or T button to select On, then press the ENTER button.
The Anynet+ (HDMI-CEC) function is enabied.
_-_ if you select Off, Anynet+ (HDMI-CEC) is disabled.
_-- When the Anynet+ (HDMFCEC)function is disabled, all the Anynet + related
operations are deactivated.
_net+ Device to turn OffAutomaticall¥ when the TV is Turned Off
2 Press the A or T button to select Auto Turn Off, then press the ENTER button.
3 Press the A or T button to select On, then press the ENTER button.
The Auto turn off function is enabled.
if you select Off, the Auto turn off function is canceled.
Press the EXiT button to exit.
_-- The Select Device setting of the TV remote control is to be set to TV to use the Anynet + function.
if you set Auto Turn Off to On, connected external devices are aiso turned off when the TV is turned off.
However, if the device is recording, it may not be turned off.
Scanning and Switching between Anynet + Devices
1
2
3
Press the Anynet + button.
Anynet + devices connected with the TV are tisted.
Press the A or T button to select to a particular device and press the ENTER
button. It is switched to the selected device.
If you cannot find a device you want, press the A or _' button to select Searching
Connections, then press the ENTER button.
The message Configuring Anynet + connection.., is displayed.
When searching devices completes, the connected devices are listed in the
Anynet+ menu.
_,_ Switching to the selected devices may take up to 2 minutes. You cannot cancel the
operation during the switching operation.
_-- The time required to scan for devices is determined by the number of connected
devices.
When the device scan is complete, the number of found devices is not displayed.
_-- Although the TV automatically scans devices when it is turned on using the POWER button, devices connected when
the TV is already on are not displayed in the device list. In this case, select the Searching Connections menu to search
devices.
_-- If you have selected external AV device by pressing the SOURCE button, you cannot use the Anynet + function. Make
sure to switch to an Anynet + device by using the Anynet + button.
Continued...