DuraHeat DFA-45T Manual Del Usuario página 7

NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
Hot Air Outlet
Fuel Tank Flange
Wheel Support
Nut
Split Pin
Wheel
Flat Washer
Figure 7. Wheel and Handle Assembly, DFA-125T MODEL ONLY
NOTE : Heater should be inspected before each use, and at least annually by a qualitied service person.
DFA-170C/DFA-210C MODELS ONLY
1. Assembling wheel & handle
1) Slide axle through wheel support frame.
Install wheel bushingsm, wheel on axle.
NOTE : When installing wheels, tube valve should face out from supprot frame (See Figure 8).
2) Place flat washers and split pins on axle ends and bend split pins with long nose plier to secure.
3) Place wheel cap on flat washers and put wheel cap in flat washers end.
4) Place heater on wheel support frame. Make sure air lnlet end (Rear) of heater is over wheels.
Align the holes on fuel tank flange. Insert screws through handles (Front and Rear), fuel tank flange,
and wheel support frame as shown in figure 8 and attach nut finger tight after screw is inserted.
5) After all screws are inserted, tighten nuts firmly.
NOTE : The height of Front handle is higher than Rear handle.
2. Assembling Cord Wrap.
1) Align the hole on the handle (Front and Rear) with the mounting hole on the cord wrap (See Figure 8)
2) Insert screws through cord wrap, handles (Front and Rear) an shown in Figure 8 and attach nut finger
tight after each screw is inserted.
3) After all screws are inserted, tighten nuts firmly.
CAUTION : DO NOT OPERATE heater without support frame assembled to tank.
Handle
Screw-S
Screw-L
Flange Screw
6
Extended Hub