DuraHeat DFA-45T Manual Del Usuario página 6

NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
2. ASSEMBLY
A. For DFA-45T/DFA-70T Models Only (Figure 6)
Tools Required
• Medium Phillips Screwdriver
1. Lift front guard for arrow direction and make
sure that guard's wedged portion fits into the slit
hole in the upper shell and faces the hot air outlet.
2. Align the holes in the upper shell with the 2
mounting holes on the handle as shown in Figure 6.
3. Insert screws into the holes in the handle and tighten
each screw.
B. For DFA-125T / DFA-170C / DFA-210C Models Only (Figure 7, 8)
These models are furnished with wheels and handles
and cord wrap (DFA-170C/210C Models Only)
Wheels, handles, cord wrap and the mounting hardware are found in the shipping carton.
Tools Required
• Medium Phillips Screwdriver
• 5/16"(M5) open or Adjustable Wrench, Use US(Inch) Screws Nuts
• Long Nose Pliers
DFA-125T MODEL ONLY
1. Slide axle through wheel support frame. Install wheels on axle.
NOTE : When installing wheels, point extended hub of wheels toward wheel support frame
(See Figure 7)
2. Place Flat washers and split pin on axle ends and bend split pins with long nose pliers to secure.
3. Place heater on wheel support frame. Make sure air inlet end (rear) of heater is over wheels. Align the
holes on fuel tank flange with holes on wheel support frame.
4. Position the handle on top of fuel tank flange. Insert screws through handles, fuel tank flange, and
wheel support frames as shown in Figure 7 and attach nut finger tight after each screw is inserted.
5. After all screws are inserted, tighten nuts firmly.
CAUTION : DO NOT OPERATE heater without support frame assembled to tank.
5
Figure 6