Giordani shuttle Manual De Instrucciones página 10

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 11
release the harness, press the buckle's red
button (Fig.11/
).
B
FITTING THE HARNESS
12.
To tighten the harness: Pull on the
adjusting straps positioned on the harness.
You do not need to press on the adjuster
buttons.
IMPORTANT:
A correctly adjusted
harness is essential for your child's
protection. There should not be more than
finger's width between the harness and
your child.
13.
To loosen the harness: Press on the
adjuster buttons positioned on the upper
section of the harness, grasp the lower
section and pull simultaneously
RECLINING YOUR CHILD SEAT
14.
Push the adjustment lever located under
the front of the seat upwards, then pull or
push the base towards or away from you.
MAINTENANCE RECOMMENDATIONS
All the material parts can be removed.
Slight stains can be removed using a damp
sponge soaked in soapy water or it can be
washed by hand at 30°C in soapy water.
Do not use bleach, do not iron, do not
machine wash, and do not tumble dry.
COMPOSITION
SHELL: 100% Polypropylene
RED AND BLUE LOCK OFF CLIPS: 100% Nylon
AXES, SCREWS AND SPRINGS: Galvanised
steel
COVER: 100% Polyester
SIZES
L: 54 cm; H: 63 cm; W: 44 cm;
SAFETY INSTRUCTIONS
PLEASE READ THESE INSTRUCTIONS
CAREFULLY BEFORE BEGINNING THE
INSTALLATION. IF THE SEAT IS NOT
INSTALLED CORRECTLY, YOUR CHILD'S
SAFETY MAY BE AT RISK. DO NOT USE
THIS CHILD SEAT ON A PASSENGER SEAT
FITTED WITH AN AIR BAG!
The seat may be installed in a front-facing
or rear-facing position with a 3-point safety
belt to UN/ECE No.16 standard or equivalent.
Do not use it on side-facing or rear-facing
seats.
Always remember to fasten and correctly
adjust the child's harness and never start
the car without first checking that the seat
is properly fixed to the passenger seat as
shown in these instructions.
It is important to check that the straps
of the seat belt are fully tightened and
that the harness lap strap is positioned
as low as possible to support your
child's pelvis.
Check that the seat belt and harness straps
are not twisted.
For maximum protection, there must be
no slack between the car seat and the
passenger seat.
Please refer to the method recommended in
these instructions.
The seat must not be modified in any way
and no elements should be added.
It is recommended that you replace this car
seat if it has been subjected to a severe
impact following an accident or in case of
wear.
You should regularly check that the harness
is not showing signs of wear; check in
particular the harness points, the seams
and the adjustment devices.
Never leave your child unattended in the seat.
Check that no part of the seat is trapped in
the door or in a fold-down passenger seat.
If your car has a fold-down rear seat, check
that it is correctly locked in the vertical
position.
Direct exposure to the sun increases the
temperature inside vehicles.
For this reason, you are advised to cover
the child's car seat when not in use in
order to prevent the elements, in particular
the fixations, from getting hot and burning
the child.
Do not use your car seat without its cover
and only replace it with a cover that has
been recommended by the manufacturer.
In an emergency, the child must be able
to be freed quickly.
The buckle, which can be easily opened,
must therefore not be covered.
Teach your child not to play with the buckle.
Always remember to check that there are
no scraps of food or other remains in either
the harness buckle or the central adjuster.
Luggage and other heavy or sharp objects
must be fixed down in the car.
Objects that are not attached may injure
a child in the event of an accident.
In winter, make sure that the child is not
wearing over-bulky clothes.
18
WARNING
This car seat is a "Universal" child restraint
system. It has been approved in accordance
with regulation N°44/04, and is suitable for
general use in vehicles and is compatible
with the majority (some exceptions) of
vehicle seats.
It is more likely that the seat is perfectly
compatible if the vehicle manufacturer
states that its vehicles are suitable for
taking "Universal" child restraint systems.
This restraint system is classified as
"Universal" in accordance with the strictest
approval criteria, whereas earlier models do
not correspond to these new provisions.
It can only be adapted to vehicles with 3-
point safety belts that are either fixed or
have a roller mechanism and that have been
approved compliant with the UN/ ECE N° 16
or other equivalent standards.
If in doubt, contact the manufacturer or
retailer of the restraint system.
Store this instruction manual, depending on
the model of your vehicle, either in the pouch
provided, or by slipping it between the shell
and the cover of the seat.
FOR TECHNICAL OR COMMERCIAL REASONS,
GIORDANI RESERVES THE RIGHT, AT ANY
TIME AND ALSO ONLY IN A SPECIFIC
COUNTRY, TO MODIFY THE TECHNICAL
CHARACTERISTICS
OF
THE
MODELS
DESCRIBED IN THIS LEAFLET, AND/OR THE
SHAPE, TYPE AND NUMBER OF THE
ACCESSORIES SUPPLIED.
19
loading