Idiomas disponibles
Idiomas disponibles
Step 5: Attach the mounting plate to your junction box using the
screws included with your junction box, making sure that the
gasket is properly aligned and that all screws are tightly
secured. To prevent moisture from entering the junction box,
apply a bead of silicone sealant around the edge of the
mounting plate where it attaches to the junction box.
What to do if . . .
LIGHT DOES
NOT COME ON
LIGHT COMES ON FOR
ONLY A FEW SECONDS
LIGHT STAYS ON
OR
LIGHT COMES ON
RANDOMLY
Two year limited warranty
Cooper Lighting ("the Company") warrants this product ("the product")
against defects in material or workmanship for a period of two years
from date of original purchase, and agrees to repair or, at the
Company's option, replace a defective product without charge for
either replacement parts or labor during such time. This does not
include labor to remove or install fixtures. This warranty is extended
only to the original purchaser of the product. A purchaser's receipt or
other proof of date of original purchase acceptable to the Company is
required before warranty performance shall be rendered.
This warranty only covers product failure due to defects in materials or
workmanship which occurs in normal use. It does not cover the bulb
or failure of the product caused by accident, misuse, abuse, lack of
Is there power to the fixture?
• Has the house circuit breaker tripped?
• Is the wall switch ON?
Is the bulb(s) plugged or screwed in completely?
• Is the bulb(s) good?
(Be careful not to o vertighten.)
Is the light sensor able to determine darkness?
• Cover light sensor with electrician's tape . Wait
2-3 minutes to see if light turns on. If it does, the
sensor is receiving too much light.
Is the wiring to the unit loose?
TURN OFF POWER BEFORE CHECKING.
Is the light sensor sensing reflected light?
• Cover light sensor with electrician's tape. Wait 2-3
minutes to see if light turns on. If it does, fixture is
receiving reflected light. Partially cover the light
sensor to block out the reflected light.
Is the light sensor in a shaded area?
• Shine a flashlight into the light sensor for 2-3
minutes. If the light turns off, the fixture is
mounted in an area that does not allow enough
light to enter the light sensor.
Is the light sensor good?
• Shine a flashlight into the light sensor for 2-3
minutes. If the light does not turn off, the light
sensor is bad. Contact customer service.
4
(continued)
