Pump Servicing Instructions - Rotor Inspection; Pump Servicing Instructions - Pump Replacement 15 - Polygroup SUMMER WAVES RX600 Manual Del Usuario

STEP 2: Rotor Inspection/Replacement
1. Loosen the Volute Cover Lock Nut
2. Pull the Rotor Assembly out from the Pump Body .
22
3. Inspect the Rotor (see image below) to make sure that the Rotor Shaft, Magnet Axle, Impeller and other parts are intact. If either of them is broken, you
can purchase a new Rotor Assembly from polygroupstore.com without having to replace the whole Pump.
For more details, please see Pool Support – Filtration System Troubleshooting – RX System at support.polygroupstore.com
RX600/RX1000
4. Once the inspection or replacement is done, carefully insert the Rotor Assembly back into the Pump Body. The force of the magnet will pull the Rotor down in place.
5. Align the Volute Cover with the top End Cap of the Rotor, then tighten with the Volute Cover Lock Nut or Bolts & Nuts (depends on the pump model).
6. Attach the Rubber Nozzle to the outlet of the Motor Assembly.
18
STEP 3: Pump Replacement/Reassembly
1. Lubricate the Canister Gasket , then insert it back into the groove
16
at the bottom of the Canister .
17
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8AM to 5PM MST, Monday-Friday.
or Bolts & Nuts (depends on the pump model), and remove the Volute Cover .
24 25
21
24
Rotor Assembly Parts
23
22
21
Step 1
16
Extended operating days and hours during peak season requirements.
OWNER'S MANUAL
Shaft End Cap
Washer
Impeller
Magnet Axle
Rotor Shaft
(This shaft should go through
all the parts and into both
Shaft End Caps)
Washer
Shaft End Cap
2. Place the cord of the Motor Assembly
Step 2 Cord
15
23
25
23
22
21
RX1500
through the Pump Base .
19 15
19
15