System Control Panel - Briggs & Stratton FORTRESS Manual Del Usuario

System Control Panel

The system control panel, located inside the generator
enclosure, is shown below. The features of the control
panel and their locations are shown below.
A
B
C
A - Menu/Programming Navigation Buttons - see Menu
for details
B - USB Port - service dealer use only
C - Generator Operation Control Buttons -
• "AUTO" Normal operating position. Press and hold
button to put unit into Automatic mode. If a utility power
outage is sensed, the system will start the generator.
When utility power is restored, AUTO allows the
internal temperatures of the engine to stabilize, then
shuts off the generator and waits for the next utility
outage.
AUTO LED - LED will light when unit is placed into
AUTO mode. LED will also blink if exercise cycle is not
set or is set to OFF.
• "OFF" Turns off running generator, prevents unit from
starting, and resets any detected faults.
OFF must be pressed and held for more than 5
seconds in order to reset service codes.
• "MANUAL" Used to manually start the generator.
MENU
ESC
AUTO OFF
MANUAL
D - 15 Amp Fuse - protects the standby generator DC
control circuits. If the fuse has 'blown' (melted open)
or was removed, the engine cannot crank or start.
Replace the fuse using only an identical ATO 15A fuse.
One spare fuse is supplied with the unit.
E - Cover - must be opened to access the fuse and the
USB port.
F - Digital Display - shows generator mode, menu
options, service codes, and service engine indicators
F
E
D
23