Inset Ceiling Mounting - Axis 231D Manual De Instrucciones

AXIS 231D/232D Installation Guide

Inset Ceiling Mounting

Control
button
Network
connector
Connection module
connector
Power
Indicator
Network
Indicator
Follow these instructions to mount the dome camera:
1. Place the decoration ring on the ceiling and mark the three screw holes and the inner
circle of the decoration cover.
2. Cut the hole in the ceiling according to the markings.
3. Insert the mounting bracket in the ceiling with the holders folded in. Once in place, fold
out the holders over the inner ceiling and secure the bracket by tightening the screws.
4. Connect the connection module cable to the connection module.
5. Connect the Ethernet cable and connection
module to the AXIS 231D/232D.
6. Connect the power cable (24V AC) to the
connection module and check that the power and
network LEDs light up green.
7. Push the dome body up into the installed bracket
and twist it clockwise to lock it into the bracket.
8. Make sure the screw hole on the side of dome is
aligned with the bracket. Tighten the fixing screw
to secure the dome.
9. The hardware installation is now complete,
proceed to Setting the IP address, on page 8 to install the AXIS 231D/232D on your
network.
Fixing screw
Serial number
S/N
Ceiling
Decoration ring
PS GND not used
24V AC
Connection module cable connector
Page 7