Tabla de contenido
7.
• Place assembled gun and wand on pressure
washer holder.
- Lift the pull cord handle up and slide the cord to
the left sliding the cord into the wire loop.
- Next slide handle behind the wire bracket to the
left of the wire loop.
- Engine recoil will pull the cord into its final
position.
8. • Place pull cord into the wire bracket holder.
- Pull the cord under the wire bracket to the right
of the wire loop.
Checklist
Before going any further please review the following:
• Be sure you have completed assembly instructions.
• Double check all fittings to be sure they are tight.
IMPORTANT: Before any attempt to start your pres-
sure washer be sure to check engine oil (See Operation
under Engine Oil, page 8.)
Know Your High Pressure
Washer
Read this Owner's Manual and Safety Rules
before operation of your High Pressure Washer
Compare this illustration with our pressure washer
to familiarize yourself with the location of various
controls and adjustments. Save this manual for
future reference.
GUNWAND
PUMP- Develops high pressure.
HOSE
PRESSURE REGULATOR- Allows you to adjust the
pressure of the outlet stream.
ENGINE RUN/STOP
LEVER- Sets engine in starting
GAS
mode for recoil starter -- Stops running engine.
RECOIL STARTER- Used for starting the engine
manually.
SPRAY GUN ASSEMBLY- Controls the application of
water onto cleaning surface with trigger device.
OIL FILL- Port where engine ell is poured.
CHOKE
GAS TANK/CAP- Cap is removed and unleaded
gasoline is poured.
CHEMICAL
INJECTION TUBE AND FILTER- Mixes
water and detergent in outlet water flow.
HIGH PRESSURE OUTLET- Connection for high
pressure hose.
CHOKE- Lever used for starting unit.
HOSE
REGULATOR
RECOIL
WATER INLET
HIGH PRESSURE
OUTLET
Tabla de contenido
