Worx WX169L Manual De Instrucciones página 9

SYMBOLS
WARNING–To reduce the risk of
injury, user must read instruction
manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Do not expose to rain or water
Do not burn
Li-Ion battery. separate collection,
and battery must be recycled
POSITEC Inc. has established
a partnership with the RBRC
Corporation to recycle any
Positec batteries with the RBRC-
call2recycle seal. For environmental
protection, please do not discard
batteries in the trash. After the
batteries' life cycle is ended, then
please call 1-800-822-8837 for a free
service that will properly dispose of
the battery.
20V Cordless Drill / Driver
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
WARNING: Use clamps or another
practical way to secure and support the
workpiece to a stable platform. Holding the
work by hand or against your body leaves it
unstable and may lead to loss of control.
1. TO REMOVE OR INSTALL BATTERY
PACK (See Fig. A, B)
Depress the Battery Pack Release Button (6) to
release and slide the Battery Pack (7) out from
your tool. After recharge, slide it back into your
tool. A simple push and slight pressure will be
sufficient.
2. ON/OFF SWITCH (See Fig. C)
Depress the On/Off switch (8) to start and
release it to stop your drill. The On/Off Switch
is fitted with a brake function which stops your
Chuck immediately when you quickly release
the switch.
It is also a variable speed switch that delivers
higher speed and torque with increased
trigger pressure. Speed is controlled by the
amount of switch trigger depression.
WARNING: Do not operate for
long periods at low speed because
excess heat will be produced internally.
3. SWITCH LOCK
The On/off Switch (8) can be locked in the OFF
position. This helps to reduce the possibility of
accidental starting when not in use. To lock the
On/off Switch, place the Rotation Control in
the center position.
4. REVERSIBLE (See Fig. D1, D2)
For drilling and screw driving use forward
rotation marked "
left). Only use reverse rotation marked "
(lever is moved to the right) to remove screws
or release a jammed drill bit.
WARNING: Never change the
direction of rotation when the
Chuck is rotating, wait until it has
stopped!
" (lever is moved to the
EN
9
"