golmar Vista Plus Rock Serie Manual De Instalación página 54

TELEPHONES PROGRAMMING
P
rogramming the
Locate the configuration dip switch on the back of the door panel and set
switch number 2 to ON. The door panel will emit a tone to advise that
the system has entered into programming mode. In systems with more
than one door panel, the programming process shall be done on the
master door panel only.
Master
Each apartment must have one master unit only; in case of parallel units configure them
as slaves, whether they are monitors or telephones.
T-730/R5 telephones.
With the door release push button pressed,
lift the handset off the telephone.
To show that the system is ready for programming,
the door panel and handset will emit a tone,
and audio communication can be established.
Release the door release push button.
With the handset lifted:
If programming the telephone as master, replace the
If programming it as slave, press the door release
Slave
Make a call to check that the telephone has been successfully
programmed. Repeat these steps to program the rest of telephones.
Once the programming has finished, set the programming switch
to OFF. If you don't, the door panel will reproduce a sound to
advise that the system is still into programming mode.
Press the door panel push button.
At this moment both door panel and
handset will emit tones.
handset.
push button, then replace the handset.
53