golmar Vista Plus Rock Serie Manual De Instalación página 42

INTRODUCTION
First of all we would like to thank and congratulate you for the purchase of this product manufactured by
Golmar.
The commitment to reach the satisfaction of our customers is stated through the ISO-9001 certification
and for the manufacturing of products like this one.
Its advanced technology and exacting quality control will do that customers and users enjoy with the
legion of features this system offers. To obtain the maximum profit of these features and a properly wired
installation, we kindly recommend you to expend a few minutes of your time to read this manual.
INDEX
Introduction ...........................................41
Index.....................................................41
Safety precautions ...................................41
System characteristics ..............................42
System operation ....................................42
Important note........................................42
Definition ..............................................43
Minimum requirements............................43
Door panel ................................................
Installation ..........................................44
Configuration ......................................45
Final adjustments .................................46
Power supply installation ..........................47
Lock release installation ...........................47
Tekna R5 monitor ........................................
Description..........................................48
Function push buttons ...........................48
SAFETY PRECAUTIONS
O Install or modify the equipment without the power connected.
O The installation and handling of these equipments must be performed by authorised personnel.
O The entire installation must be at least 40 cm. away from any other installation.
O With power supply:
w Do not use excessive force when tightening the connector screws.
w Install the power supply in a dry and protected place without risk of drip or water projections.
w Avoid to place it near to heating sources, in dusty locations or smoky enviroments.
w Do not block ventilation holes of the unit so that air can circulate freely.
w To avoid damage, the power supply has to be firmly fixed.
w To avoid an electrical shock, neither remove the protection cover nor handle the connected wire in
the terminals.
O With monitor, telephones and distributor:
w
Do not use excessive force when tightening the connector screws
w Install the equipments in a dry and protected place without risk of drip or water projections.
w Avoid to place it near to heating sources, in dusty locations or smoky enviroments.
w Do not block ventilation holes of the equipments so that air can circulate freely.
O Before to connect the system, check the connections between door panel, monitors and telephones,
and the transformer connection. Do always follow the enclosed information.
O Each time the power supply is restarted, or after a modification, the system will remain blocked
during 45 seconds.
End of line resistor.................................49
Monitor connection block description......49
Monitor installation...............................50
Programming.......................................51
T-730/R5 Telephone ...................................
Installation ..........................................52
Function push buttons ...........................52
Programming.......................................53
IMPORTANT considerations................54-55
Optional connections..................................
Parallel monitor or telephone .................56
External lock release activation...............56
Additional call repeater connection.........56
Installation diagrams..........................57-58
Troubleshooting hints ..............................59
Notes...............................................60-62
Compliance...........................................63
.
41