Husky H15123TK Manual Del Operador página 21

5) Using a suitable Allen wrench (G), remove screws (M)
- (N) and (O) located in the top part of the brad/stapler
(Fig. 19).
6) Remove cover (I) of the brad/stapler (Fig. 20).
7) Remove the jammed nail.
8) Replace cover (I) of the brad/stapler.
9) Using a suitable Allen wrench (G), refasten screws (M)
- (N) and (O) to cover (I).
10) Slide the outer part of cartridge (C) upwards, pressing
lever (D) at the same time (Fig. 17).
11) Lock the outer part of cartridge (C), releasing lever (D).
Make sure that the cartridge is firmly secured (Fig. 18).
12) Connect the brad/stapler to the compressor as
explained in the Compressor manual at chapter
"OPERATION - USING THE AIR COMPRESSOR".
13) Once the compressor has been restarted, the brad/
stapler is ready for use again.
WARNING:
FASTENER AND REPLACEMENT PARTS
Use only genuine Husky 18 gauge fasteners (or
equivalent. Fasteners not identified for use with this
tool by the tool manufacturer are able to result in a risk
of injury to persons or tool damage when used in this
tool). Tool performance, safety and durability could be
reduced if improper fasteners are used.
When ordering replacement parts or fasteners, specify
by part number.
TOOL REPAIR
Only qualified personnel should repair the tool, and
they should use genuine Husky replacement parts and
accessories, or parts and accessories which perform
equivalently.
After use, always store the pneumatic tool in a dry, clean
environment. Do not use solvents, flammable or toxic
liquids for cleaning.
BRAD/STAPLER
G
A
21
M
O
N
I
B
Fig.19
Fig.20
Fig.21