Operations; Switching On/Off; Unit Setting - Craftsman 25466 Instrucciones Para El Usuario

Operations

Switching ON/OFF

ON
Device is turned
OFF.
Surface-to-Surface Measuring
1. Press and release the ON button to activate the laser. A red laser dot will appear on any target surface at which the
device is aimed, and a measurement will appear in the device display. The measurement represents the distance from
the base of the device to the target.
2. Place the base of the device against the surface from which you want to measure. Shift the base of device until the red
laser dot appears steadily on the target surface to which you want to measure.
3. Press and release the ON button again to lock the target distance in the display for easy reading. The laser dot
disappears when the distance locks in the display. To resume measuring, press and release the ON button.
NOTE:
The device does not measure distances less than 1' 5".
1 2
3
If the ON key
OFF
is not
i
pressed for 2
minutes, the
5 sec
device
automatically
switches off.
Aim active laser at target.
LASER DISTANCE MEASURE

Unit setting

Switch between the
following units:
0'
3 sec
00 1/8
0.00 ft
0.000 m
Target surfaces: Inaccurate readings can occur
i
when measuring to colorless liquids, glass,
3
Styrofoam, or semipermeable or high gloss surfaces.
9.33
ft.
09-25466
00 1/8 ''
''