Clock Set - Haier AS09SH1ERA Manual Del Operador

Operation
Inner side of the controller
SMART
SET TEMP. ROOM TEMP.
COOL
HEAT
FAN
DRY
AUTO AUTO
CTD
FAN
AUTO
SPEED
POWER
SOFT
ECO
iFP
TIMER ON OFF
AM
PM
26
SMART
25
24
23
22
21
20
19
18
18.CODE button
Used to select CODE A or B
with a press, A or B will be
displayed on LCD.Please
select A without special
explanation.
19.RESET button
When the remote controller
appears abnormal,use a
sharp pointed article to
press this button to reset
the controller normal.
20.INQUIRE button
Inquire the external
environmental temperature
and the operating power of
the machine. (e.g. when the
panel display "01", the
This function unavailable on this models.
Loading of the battery
1
Remove the battery cover;
2
operating power is 100W;
when the panel display "02",
the operating power is
200W, and so forth)
21.LIGHT button
Control the lightening and
extinguishing of the indoor
LED display board.
The manual of how to change
the default display temp：
Press LIGHT button
27
continuously for ten times, the
display temp on display panel
can be changed between
28
ambient temp and set temp.
29
22.POWER / SOFT button
30
23.10
special heating set function:
31
10 degree heating maintaining
32
(valuable for RS)
24.HEALTH AIRFLOW
33
button
34
25.HEALTH button
26.SWING UP/DOWN
button
27.SWING LEFT/RIGHT
button
28.FRESH button
29.SLEEP button 30.TIMER ON / OFF button
31.HOUR button
32.CANCEL/CONFIRM
button
Used to confirm timer and
clock settings.
33.CLOCK button
34.LOCK button
If pressed, the other buttons
will be disabled. Press it once
again,lock will be cancelled.
2
Load the batteries as illustrated. 2 R-03
batteries,resetting key(cylinder); Be sure
that the loading is in line with the " + "/"-";
3
Load the battery,then put on the cover
again.

Clock set

AM
PM
SMART
Note:
The distance between the signal transmission head and the
receiver hole should be within 7m without any obstacle as well.
When electronic-started type fluorescent lamp or change-over
wireless telephone is installed in the type fluorescent lamp or
room, the receiver is apt to be disturbed in receivingthe signals,
so the distance to the indoor unit should be shorter.
Full display or unclear display during operation indicates the
batteries have been used up.Please change batteries.
If the remote controller can't run normally during operation,
please remove the batteries and reload several minutes later.
Hint:
Remove the batteries in case unit won't be in usage for a
long period.If there are any display after taking-out,just need
to press reset key.
1
Press CLOCK button,
"AM" or "PM" flashes.
2
Press "+" or "-" to set
correct time.
Each press will increase or
decrease 1min.If the button
is kept pressed,time will
change quickly.
3
Confirm time.
After time setting is confirmed,
press CONFIRM,"AM "and
"PM" stop flashing,while
clock starts working.