COMENDA Hi-Line HB Serie Instrucciones Para El Uso Y El Mantenimiento página 28

ENGLISH
IMPORTANT
A
ny installation, electric or hydraulic connection,
programming, maintenance operation etc. must be
carried out by SUITABLE qualified personnel authori
sed by the manufacturer; operations carried out by
UNQUALIFIED personnel can jeopardise the safety
of the operator as well as other personnel (user, etc.)
or the system connected to the dishwasher.
The manufacturer will not be held liable for accidents to
persons or objects resulting from failure to comply
with the rules specified above.
3.1 INSTALLATION (Fig. 6)
- After having removed the packaging, make sure that
the machine is intact and that all the supplied parts are
present.
- Position the machine at its final installation site and
level it by acting on the adjusting feet (22).
3.1.a Drain hose connection (Fig. 6)
- Connect the drain hose (5) to the overflow trap and
the other end to the drain pump.
IMPORTANT
I
t is essential to make sure that the drain hose runs flush
along the floor and has no bottlenecks
3.1.b Water connection (Fig. 6)
- Connect the supplied filler hose (4) to the solenoid
valve and the other end of the filler hose (4) to a 3/4"
G threaded valve and apply the filter (8).
ATTENTION
I
t is mandatory to connect the cold water supply hose
to a partialisation valve in order to separate the supply
system from the machine itself and to check that there
are no bottlenecks.
Wherever sand is found in the water supply circuit, a filter
must be applied between the water circuit and the machine.
If it has none, it is recommended to install a descaler
upstream of the machine with calibration min 4 max. 8
French degrees.
The manufacturer will not be held liable for damaged
to the machines resulting from failure to comply with
the rules specified above.
26
Part 3: Reserved for Author. and Qualified Techn.
3.1.c Electric connection (Fig. 5)
- Before performing the electrical connection, make
sure that the data on the power line correspond to
those indicated on the rating plate (pos. 3 Fig. 5)
and that the main electric power switch upstream
of the machine is disconnected " O " OFF.
- An ominpolar power switch, appropriately sized
with a minimum contact opening of 3 mm must be
installed between the power line and the machine
- Connect the power cable (6) to the main switch
upstream of the machine.
- Connect the equipotential earth electrode to the
terminal (7).
- The power cable CANNOT replaced by the
user but ONLY by technical assistance.
- There must be an efficient earthing system, com-
pliant with prevention standards in force, for the
safety of the operator and of the equipment.
- The power cable must not be pulled or crushed
during normal operation or routine maintenance.
- The equipotential terminal fixed to the body must
be connected to an equipotential cable with a cross-
section suitable to the application.
- Respect the polarities of the wiring diagram.
- For further information, see the attached wiring
diagram.
The manufacturer will not be held liable for accidents to
persons or objects resulting from failure to comply
with the rules specified above.
DANGER