Mounting Instructions - D-Link DCS-4802E Guia De Instalacion

Mounting Instructions

It is highly recommended that you configure and test your camera before mounting it.
Place the mounting sticker where you want to position the
camera.
Use a 6 mm drill bit to make the required holes
approximately 25 mm deep, then insert the wall anchors
into the holes.
If you are running the camera cables through the wall
or ceiling, drill a hole in the center and pull the cables
through the hole. If not, then guide the camera cables
through the cable channel on the base after mounting to
the wall or ceiling.
Use the screws provided to mount the camera to the wall
or ceiling.
Attach the camera base cover by lining up the cable
channel with the mark on the camera base, then turn the
camera base cover clockwise until it clicks.
6
D-Link DCS-4802E Quick Installation Guide