Mounting Instructions - D-Link DCS-4802E Guia De Instalacion

Mounting Instructions

It is highly recommended that you configure and test your camera before
mounting it.
Place the mounting sticker where you want to
position the camera.
Use a 6 mm drill bit to make the required holes
approximately 25 mm deep, then insert the wall
anchors into the holes.
If you are running the camera cables through
the wall or ceiling, drill a hole in the center and
pull the cables through the hole. If not, then guide
the camera cables through the cable channel on
the base after mounting to the wall or ceiling.
Use the screws provided to mount the camera to
the wall or ceiling.
Attach the camera base cover by lining up the cable
channel with the mark on the camera base, then
turn the camera base cover clockwise until it clicks.
6
D-Link DCS-4802E Quick Installation Guide