Changing The Retransfer Ribbon - Rimage Everest III Manual De Instrucciones

Changing the retransfer ribbon

Before you change the Everest retransfer ribbon, allow time for the new ribbon to become
acclimated to the environment. Allow more time for greater temperature and humidity differences.
Important! Ribbons must be stored at a temperature between 50°– 90°F (10°– 32°C). Avoid
moisture and direct sunlight. Do not reuse ribbons.
1. Power off the printer.
2. Remove the retransfer ribbon.
a. Press the two side cover latches to
release the side cover.
b. Lower the side cover.
c. Open latches 1, 2, and 3.
d. Pull out the retransfer ribbon carrier.
Note: The retransfer ribbon carrier
cannot be removed from the printer.
e. To remove the retransfer ribbon from
the carrier, lift the retransfer rolls up
and carefully slide the retransfer
ribbon from the retransfer ribbon
carrier.
3. Discard the used retransfer ribbon.
110875_A
Maintain the Everest printer
Side cover latches
Side cover
Retransfer ribbon carrier
Latch 2
Latch 3
23