Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1.2 PED Function (or CH2)
Press P2 button until PROG LED starts flashing; do not release P2 and wait for the flashing to become faster. Release P2
button
Enable the remote control key to be saved that you want to assign to the PED control within 10 seconds. Saving is completed
when the PROG LED will flash for a longer time.
Repeat the operation for each remote control to save.
1.3 Deleting a single remote control
Press P2 button until PROG LED starts flashing; do not release P2 and wait for the flashing to become faster; do not release
P2 and wait for the flashing to become very fast. Release P2 button.
Enable the key of the remote control that you want to delete within 10 seconds. Delete operation is completed when the
PROG LED will flash for a longer time.
Repeat the operation for each remote control to delete.
1.4 Deleting all remote controls
Switch the equipment on by pressing the P2 button until the PROG LED starts flashing; do not release the button and wait for
the flashing to stop. ALL remote controls are deleted when the PROG LED will flash for a longer time.
2) STROKE PROGRAMMING
During saving, beside saving the slowing down spaces and the pedestrian opening stroke, the equipment will detect any
supervised safety input PH1, PH2 or SAF.
Press the save button P1 for at least 3 seconds
The PROG LED starts flashing: Release P1 button
Enable SEQ pulse: The gate closes at normal speed
The gate searches the limit switch in closed position and stops.
After about 1 sec: The gate opens at normal speed
When you decide to start the slowing down stroke phase, enable SEQ: the gate slows down
The gate reaches the limit switch in open position and stops
After about 1 sec: The gate closes at normal speed
When you decide to start the slowing down stroke phase, enable SEQ: the gate slows down
The gate reaches the limit switch in closed position and stops.
After about 1 sec: The gate opens at normal speed
To fix the partial pedestrian opening, enable SEQ: the gate stops
After about 1 sec: The gate closes until the limit switch in closed position is reached and stops. Wait for the PROG
LED to turn off.
During stroke programming phase, if the stop time (TR1 trimmer DELAY) is set to 0 seconds, the pedestrian control will set to
stop time of 1 second of TR2 DELAY which cannot be changed; while if strokes are learned with DELAY > than 1 second, the
TR1 trimmer DELAY also changes the pedestrian function stop time.
3
NOTES FOR MAINTENANCE TECHNICIANS
3.1 ROUTINE MAINTENANCE
You should ask the company that installs the automation to provide a scheduled maintenance plan in compliance with the
regulations for this type of equipment.
The maintenance operation suggested by Aprimatic for the electrical system
Operation
Check the efficiency and adjustment of safety devices and the anti-crush device. Check the
photocells, the detector and the safety edge
Check the efficiency of the electrical equipment. Test the efficiency of the
differential overload switch protecting the unit
Check the inside of the electrical box. Clean out any insects, dirt or dampness
Check the efficiency of the remote control batteries. Change spent batteries
Remove branches, bushes or other obstacles which might permanently obstruct or interrupt
the photocell beam
SC 230
is the
following:
Average interval
every 6 months
every 6 months
every 6 months
every 6 months
every 6 months
14
Tabla de contenido
