Skin Preparation; Start Of The Session - Driosec Iontodry Manual De Uso

3.III. Skin preparation
Make sure the area to be treated does not have any wound or
sore. If any, cover only these areas with petroleum jelly and
perform the treatment. The treatment will be ineffective in the
before-mentioned areas.
Remember to remove any jewelry (rings, etc.) you may wear on
your hands/feet.
3.IV. Start of the session
Session preparation:
Note: Before using iontodry
full-charge of the battery, in order to increase its lifetime. The battery will
be fully charged after approx. 2-4 hours. The indicator will display green in
this case, and red while charging. iontodry
anticipation of a future shrinkage.
1) Fill up a bowl with 400 ml (13.4 fl.oz.) of tap water. Remove the
EN
iontodry
44
underwater for at least 5 minutes and set them again (soaked)
in their respective treatment units. iontodry foam pads should
always cover the aluminum electrode.
iontodry
• 5 MM – Thick foam pads: specially designed for hand treatments
due to its higher skin sensitivity.
• 3 MM – Thin foam pads: specially designed for feet treatment
due to their lower skin sensitivity.
foam pads and place them in the bowl. Keep them
®
offers two types of foam pads:
®
for first time, it is recommended to take a
®
foam pads are slightly larger in
®
®