Viking 3 Serie Guía De Utilización/Instalación página 8

Installation
Shelf features
(Select Models)
CAUTION
Shelves must be removed prior to moving the
refrigerator.
CAUTION
To avoid injury from breakage, handle tempered glass
shelves carefully.
NOTE
Features may vary according to model.
Your refrigerator includes glass shelves that are designed to
catch and hold accidental spills.
You can easily adjust shelf positions in the fresh food
compartments to suit your needs. The shelves have mounting
brackets that attach to slotted supports at the rear of each
compartment.
To change the position of a shelf:
1. Before adjusting a shelf, remove all food.
2. Lift the front edge up and pull the shelf out.
3. Replace by inserting the mounting bracket hooks into the
desired support slots.
4. Lower the shelf and lock into position.
Full Custom-Design TM Shelf
or
Reposition the Air Seal
(Slide-out Shelves)
1. Remove air seal by pushing down on the fl ap with a
downward rotation.
2. Position the air seal towards the outside end of the shelf to
avoid the air tower when shelf is pushed back into place.
3. Install seal by sliding lower tab of seal up into bottom
rear slot of shelf with seal at a downward angle then
pulling up on seal fl ap until seal sits snug on back of
shelf and fl ap sits at about a 10 degree angle from shelf
surface.
Reposition the Air Seal
(Channel in rear)
1. Remove air seal by pushing seal straight back.
2. Position the air seal towards the outside edge of the shelf to
avoid the air tower when shelf is pushed back into place.
3. Install seal by sliding the open channel end of the seal
onto back edge of shelf until seal sits snug on back of
shelf and fl ap sits at about a 10 degree angle from shelf
surface.
Air Seal
8
Air Seal