Stop The Machine; Delimbing A Tree; Limb Tree Branches; Maintenance - GreenWorks Pro PH60L210 Manual Del Operador

EN
8.3

STOP THE MACHINE

1. Release the trigger to stop the machine.
8.4

DELIMBING A TREE

B
A
Make sure that there is nothing or nobody in the area where
the branches fall.
• Stand opposite the branch you will cut.
• Start to cut the higher branches.
• Then cut the lower branches.
• Cut downwards to prevent the bar from jamming.
8.5

LIMB TREE BRANCHES

Limbing is to remove the branches from a fallen tree.
1. Keep the larger lower branches to hold the log off the
ground.
2. Remove the small limbs in one cut.
3. Limb the branches with tension from the bottom to up.
4. Keep the larger lower branches as a support until the log
is limbed.
9

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
WARNING
A
A
CAUTION
English
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
9.1

ADJUST THE CHAIN TENSION

Wear protective gloves if you touch the chain, bar or areas
around the chain.
1. Loosen the chain cover by turning the bar nut
counterclockwise.
It is not necessary to remove the chain cover to adjust the
chain tension.
2. Turn the chain tension screw behind the bar and chain
clockwise to increase the chain tension.
3. Turn the chain tension screw counterclockwise to
decrease the chain tension.
10
CAUTION
WARNING
CAUTION
NOTE